Volvo Penta MD2020 Oil & Filter Change
Fresh oil and a new filter are the cheapest insurance for your Volvo Penta MD2020. Below is the oil filter we recommend, which MD2020 variants it fits, a step-by-step video of the full oil change, and what else you need for the job.
Check today’s price on Amazon →
Watch: how to do it (step by step)
How to replace the oil filter on a Volvo Penta MD2020
Volvo Penta MD2020 – change oil and filter and removing sprayhood
Tools Needed
- Oil sucking tool with tubes
- Drain pump
- New oil filter (FR filter pH29f1)
- Funnel
- Dipstick
Safety
- Ensure the engine is warm before draining oil to avoid burns.
- Wear protective gloves and safety glasses.
Steps
- Start the engine and let it run for half an hour to ensure the oil is warm.
- Remove the dipstick and use a suction tool with tubes to drain the old oil from the bottom of the engine.
- Suck out as much oil as possible using the appropriate tube, ensuring you do not overfill the engine.
- Once most of the oil has been removed, remove the dipstick again to check the remaining oil level.
- Use a drain pump through the designated drain pipe to extract any leftover oil.
- Remove the old oil filter and inspect it for any contaminants or damage.
- Clean the mounting surface where the new filter will be installed.
- Moisten the rubber gasket of the new filter with a small amount of engine oil.
- Screw on the new FR filter, tightening it by hand to about half a turn as per the manual's instructions.
- Refill the engine with 2.8 liters of VTS3 certified 15W-40 mineral oil using a funnel.
- Check the oil level and ensure it is below the maximum mark on the dipstick.
Tips
- Always use the correct type of oil as specified in the manual to protect your engine.
- Ensure the engine is warm before draining oil to prevent damage or injury from hot components.
- Do not overfill the engine with oil, as this can lead to leaks and excessive pressure.
Which part do I need for my Volvo Penta MD2020?
For most MD2020 owners the part above (861473) is the right choice.
Frequently asked questions
What oil filter fits a Volvo Penta MD2020?
The Volvo Penta MD2020 uses the oil filter sold as 861473. Confirm the number against your engine's model code and year plate before ordering.
How often should I replace the oil filter on a Volvo Penta MD2020?
Change the oil and filter every 100 running hours or once a season, whichever comes first (check your manual for the exact interval).
What else do I need for an oil change on a Volvo Penta MD2020?
The correct grade and amount of engine oil (see the manual or the video), a new drain-plug washer, a filter wrench and a drain pan or oil extractor pump. Nothing exotic — it is standard service equipment.
What are the signs the oil is overdue on a Volvo Penta MD2020?
Dark, gritty oil well past its interval, low-pressure warnings — and milky or grey oil, which means water is getting in and should be investigated immediately.
How long does an oil change take on a Volvo Penta MD2020?
About an hour for a competent DIYer. Run the engine warm first — warm oil drains faster and carries more contaminants out with it.
Related guides
- Volvo Penta D4 oil filter
- Volvo Penta TAMD63 oil filter
- Volvo Penta KAD300 oil filter
- Volvo Penta KAD42 oil filter
- All Volvo Penta maintenance guides
- Free Volvo Penta boat valuation
As an Amazon Associate we earn from qualifying purchases — at no extra cost to you. Prices and availability are shown at checkout. This guide is for reference; always follow the engine manufacturer’s service manual.